Analisis Penyebab Produk Defect Selama Penyimpanan pada Perusahaan Manufaktur Plastik dengan Diagram Pareto dan Root Cause Analysis
DOI:
https://doi.org/10.31004/jutin.v8i2.41632Keywords:
Gelas Plastik, Defective products, Pareto Diagram, Root Cause AnalysisAbstract
This research was conducted in a factory that produces polypropylene, polyethylene, and high density plastics located in North Sumatra Province, Indonesia. Based on the characteristics of its products, the company implements a make to stock system. However, the products experience quite high damage reaching 20% of its total production. Therefore, this study will analyze the causes of defective products during storage in a plastic factory. In this study, historical data of damage that occurred and Pareto Diagram were used to obtain the main causes and analyze them so that defective products when stored in the warehouse can be reduced. Based on the Pareto Diagram, it was found that sticky and discolored plastics dominate the number of defective products. To prevent this, it is necessary to manage the temperature of the storage room, provide a good understanding for operators and inspect materials according to standardsReferences
Dyadem. 2003. Guidelines for Failure Mode and Analysis, For Automotive, Aerospace and General Manufacturing Industries: CRC Press.
El;Haik, Basem. 2005. Service Design for Six Sigma. Wiley Intersection Publication
Fajrin, M. H., and Sulistiyowati, W. (2018). Pengurangan Defect pada Produk Sepatu dengan Mengintegrasikan Statistical Process Control (SPC) dan Root Cause Analysis (RCA) Studi Kasus PT. XYZ. Spektrum Industri, 16(1); 29-40
McDermott., E, Robin. 2009. The Basic of FMEA. Edisi 2. USA : CRC Press.
D. H. Stamatis. (2023). Failure Mode and Effect Analysis: FMEA From Theory to Execution. In Technometrics (Vol. 38, Issue 1). American society For Quality. https://doi.org/10.1080/00401706.1996.10484424
Hu, Z., Liu, L., Ma, L., & Yu, X. (2025). SinkFlow: Fast and traceable root-cause localization for multidimensional anomaly events. Engineering Applications of Artificial Intelligence, 139(September 2022). https://doi.org/10.1016/j.engappai.2024.109582
Liliana, L. (2016). A New Model of ishikawa Diagram for Quality Assessment. in Proc. IOP Conf. Ser.: Mater. Sci. Eng. (20th Innovative Manufacturing Engineering and Energy Conference, Kozani, Greece). 161, 23-25 September 2016.
Ouyang, L., Zhu, Y., Zheng, W., & Yan, L. (2021). An information fusion FMEA method to assess the risk of healthcare waste. Journal of Management Science and Engineering, 6(1), 111–124. https://doi.org/10.1016/j.jmse.2021.01.001
Yafie, A. S., Suharyono, and Abdillah, Y. (2016). Pengaruh Kualitas Produk dan Kualitas Jasa terhadap Kepuasan Pelanggan. Jurnal Administrasi Bisnis (JAB), 35(2); 11-19.
Downloads
Published
How to Cite
Issue
Section
License
Copyright (c) 2025 Irwan Budiman, Tuti Sarma Sinaga, Tengku Heny Kartika
This work is licensed under a Creative Commons Attribution-ShareAlike 4.0 International License.
