Pengaruh Kecepatan Potong terhadap Kekasaran Permukaan Cetakan pada Mesin Milling CNC

Authors

  • Felix Thomas Fakultas Teknik, Universitas Tarumanagara
  • Sobron Yamin Lubis Fakultas Teknik, Universitas Tarumanagara
  • Rosehan Rosehan Fakultas Teknik, Universitas Tarumanagara

DOI:

https://doi.org/10.31004/jutin.v6i1.16417

Abstract

This study aims to determine the appropriate cutting speed in the milling process to produce good die surface roughness on 6061-T6 aluminum workpieces and to determine the effect of the cutting speed parameter of 30-50 mm/minute on surface roughness. Types of research methods and data collection will begin through a literature study process, by making working drawing designs then making chisel grooves and calculating VC and other parameters, followed by the milling process. Based on the results of the test data obtained, it shows that (1) Based on the graph obtained from the data table, the cutting speed (Vc) from the comparison of the base and wall between the core and cavity has where in this position the cutting speed (Vc) is 50 mm/min, which is the cutting speed (Vc) is the most optimal with engine speed (n) 1592.36 Rpm, Infeed speed (Vf) 636 mm/rev, and a constant Depth Of Cutting at 0.5. (2) The conclusion of this cutting speed (Vc) is that a high cutting speed will take faster machining time and have smoother surface roughness. (3) High cutting speed also does not justify any cutting speed. High speed must have a smooth surface roughness result. (4) Determine the characteristics of the material and then determine the right tool eye.

Downloads

Published

2023-04-24

How to Cite

Thomas, F., Lubis , S. Y. ., & Rosehan , R. . (2023). Pengaruh Kecepatan Potong terhadap Kekasaran Permukaan Cetakan pada Mesin Milling CNC. Jurnal Teknik Industri Terintegrasi (JUTIN), 6(1), 304–312. https://doi.org/10.31004/jutin.v6i1.16417

Issue

Section

Articles of Research

Most read articles by the same author(s)

1 2 > >>